Anpak 60 is a plaster used in ceramics to produce working moulds for the slip casting of sanitaryware and tableware.It can also be used for the modeling purpose for sanitary ware and tableware
Good balance between mechanical properties and absorption capability
Traditionnal plaster for sanitaryware
| Physical Properties | |
|---|---|
| Apparent Bulk Density (g/cm³) | 0,65 - 0,75 |
| Bulk density (compacted) kg / m³ | 800 - 1050 |
| Loose bulk density (kg/m³) | 650 - 750 |
| Particle Size (% weight retained) | < 0.04% at 200 µm |
| Chemical Properties | |
|---|---|
| Chemical Composition | CaSO4.1/2H2O |
| Colour | white |
| Mechanical Properties | |
|---|---|
| Dry compressive strength (Mpa) | 12 |
| Flexural Strength (MPa) | 4 |
| Hardness Shore D | 67 |
| Setting Parameters | |
|---|---|
| Initial setting time (minutes) | 13 - 20 |
| Linear Expansion (%) | max. 0.22 |
| Vicat Ring Fluidity (cm) | 18 - 22 |
| Plaster to Water Ratio | |
|---|---|
| Plaster to Water Ratio (by weight) | 1.43:1 |
| Water to plaster ratio ( by weight) | 70% |
The recommended plaster to water ratio is between 1.40:1 and 1.54:1, with a mixing time of approx. 2 to 4 minutes, depending on batch size.Mixing utensils should always be clean and free from set plaster. Use distilled water only. For consistent results, attention must be given to the correct proportioning and mixing of the plaster and water.Add the weighed quantity of plaster slowly into the measured volume of water and allow to soak. Do not mix fresh plaster with that which has been mixed for some time previouslyChanges to plaster to water ratio will influence product performance, particularly setting time and strength and absorption capability.
Packaging available : 30 kg
Shelf life : 6 months
Packaging available : 1 T, 1.25 T
Shelf life : 6 months